It does really depend on where I am at.
For the $300 mark, I could just barely make it with my Busse Basic 11.
That would just about eat up the budget (but I got it at show release prices!). So just enough left for an inexpensive smaller knife.
I have a CS pocket bushman that would balance the chopper out great.
Add a GW to the mix, and you have Big and Small.
Add a GW to the mix, and you have Big and Small. (or CS pocket bushman, or mora etc)
I made the sheath and baldric rig, so I'm gonna count that as free (mostly).
Here is the CS pocket bushman. Cheap, strong, sharp and pointy.
If I was in a location with more brush, and jungle type stuff to cut, I would opt for the Machete small nicer knife combo.
Mag Khukri machete from CS (edge is now convex, and spine exposed for fire striking).
Bites deep, even with the horrible factory edge (since convexed).
I would probably pair it up with a GW or a BAD or CABS (on the way).
Bad is the top one in this pic, just ignore the broken Comp Finish BWM in this shot. The bad is thin, with a very fine point.
Nice polished convex, with a nice blend to the primary flat grind. .22 thick but still a great slicer, and plenty fine point for detail work, plus thicker for the heavier use.