The "Ask Nathan a Question" Thread

[Fallbrook Forge]

And lower on the page he says he ordered enough steel for 300 of them. Hopefully it's a preorder scenario.

I sure hope so since that will be the only way outside of a proxy that I’ll be able to get one

 

[mb>]

Heads up. Next sale announcement is missing the date Nathan the Machinist .

 

[Retired UPS Driver]

Heads up. Next sale announcement is missing the date Nathan the Machinist .

It’s there on the bottom left:

View attachment 2249822

 

[mb>]

Good eye Retired UPS Driver . I can only see sig lines when I turn my phone sideways.

What am I doing trying to increase traffic on a sales thread anyway?! Lol

 

[carnifex knifeworks]

Good eye Retired UPS Driver

What am I doing trying to increase traffic on a sales thread anyway?! Lol

That's the real question!

 

[Casinostocks]

Completely off topic but do you think whether or not Betelgeuse has gone supernova yet?

 

[Nathan the Machinist]

Heads up. Next sale announcement is missing the date Nathan the Machinist .

Thanks

 

[jbib]

I'm 73 and all thumbs. Does anyone offer the service of installing scales on knives? I have a Spyderco that I purchased custom scales. When looking at the project I realized it was above my pay grade. Thanks!

 

[bluemax_1]

I'm 73 and all thumbs. Does anyone offer the service of installing scales on knives? I have a Spyderco that I purchased custom scales. When looking at the project I realized it was above my pay grade. Thanks!

Check with Chip WValtakis

 

[adluginb]

Completely off topic but do you think whether or not Betelgeuse has gone supernova yet?

Nope... Well actually since its 642 light years away it could have and the explosion just hasnt reached us yet. Here is me and my littlest one at a star party this spring with a couple of my scopes.

 

[DocJekl]

I'm 73 and all thumbs. Does anyone offer the service of installing scales on knives? I have a Spyderco that I purchased custom scales. When looking at the project I realized it was above my pay grade. Thanks!

I'll be lucky to still have thumbs at 73!

 

[jbib]

Check with Chip WValtakis

thank you!

 

[yoko]

Nathan the Machinist what angle are the hollow ground cruwear BFK sharpened at ?

Thank you!

 

[yoko]

Nathan the Machinist what angle are the hollow ground cruwear BFK sharpened at ?

Thank you!

Nevermind I got it!

 

[clinton1]

Nevermind I got it!

What is it? Please share!
Sorry if I missed it!

 

[yoko]

What is it? Please share!
Sorry if I missed it!

From what I'm seeing it's 20 degrees with a micro bevel

 

[Nathan the Machinist]

^ this

 

[yoko]

^ this

Sharpens out fantastic!!!!

Chips gone once again well done Nathan the Machinist !!!!!

 

[coolbreezy37]

Will there be a pre-order for these much anticipated choppers? I still have remnants of my CPK fund.

 

[ironwagon]

Hey Nathan, would you go for a 15° or 20° edge on your Cruwear BFK? I use a Sharpmaker and also I won't be going bonkers with the BFK. Thank you!