ZT0777 retired. Here comes the ZT0777M390!

Status
Not open for further replies.
Respectfully, if ZT puts out "Inside Information" for the public on their website then we're doing all a courtesy by disseminating that information widely.

Just remember that for if they do or do not hit that exact number then. If by the same token if they don't you will be first in line to explain what goes into a limited run?

I personally don't care too much about number other than for a pub pissing contest. I will wait until they are released and go by the number of the highest serial # or by the final they tell us. My panties don't seem to get as bunched up as a lot of the uninformed around here either. I hope you understand what I'm trying to get at, not being a prick here, just being honest and following the rules I was asked to.
 
I talked to BladeHQ about they change and they informed me that they were going to maintain their original pre-order list and provide them in order that the pre-order was placed.

Can't wait to get mine!
 
So is it going to be possible to get one of these if you didn't pre order one of the originals a long time ago? 1300 seems like quite a lot...
 
I'm curious if the plus or minus 1300 pcs includes the CB version as well. If it does then only 1000 or so of the M390's will be produced.
 
So is it going to be possible to get one of these if you didn't pre order one of the originals a long time ago? 1300 seems like quite a lot...
- My guess is that there will be enough to go around. The ZT0560CBCF has similar numbers and it's still available at several online retailers.

The more I look at the M390 blade, the more and more I like it.
 
Anyone have of picture of the new knife?

Post# 1 and below:

zt0777_m390_blog__657px.jpg
 
I wouldn't consider this a satin finish. Looks more like the regular stonewash. When I read "satin finish' I thought it would have the blade finish the 0801cf has.
 
I wouldn't consider this a satin finish. Looks more like the regular stonewash. When I read "satin finish' I thought it would have the blade finish the 0801cf has.

From the KAI pictures it looks more stonewash to me as well which is actually good since aesthetically it matches up better with the matte titanium clip and lockbar.
 
Beautiful. Definitely want to get one of these, I really hope there will be enough that I can order one. I can't see that there are 1000+ people out there that have one of these on preorder.
 
I'll offer anyone two of these Beautiful 777M390 an even trade for their new 777 w/composite blade :)
 
Kai thank you for the pictures.I may have to keep my ears on and try to grab one if possible when they are released.
 
Status
Not open for further replies.
Back
Top