Deep carry / low ride titanium clips for Spyderco - Delica, PM2, Manix, etc. - Run #3

theoriginalspaceman said:
Thanks J! I appreciate the great pic and the kind words.

Yessir, Chris, I just got them back. I haven't posted that yet but they are good to go.

Hey Baz. Thanks for letting me know. Part of my deal is that if you have an issue with the clip, I'll replace it, no charge. Can you email me your mailing address (thelastleaf1@gmail.com)? I'll get one out to you asap. You can also mail me back your clip and I'll fix it, so you'll have a spare.

Casey
Click to expand...
Visitor message left.
 
Any examples of the flame annodize? Tried searching through all the posts but it's hard to read through 50+ pages. I will be looking to order a flame or sandwash long in the near future.
 
Hey 3rd - as usual, I have fallen behind. But I am pretty sure everything will be good to go and ready to start shipping by this weekend. That's my goal, anyways. Sorry for the delay.

Hey Kalibr - I haven't had good success with flame ano. The ti ends up looking more burnt than colored. Andrew over at edgeobserver.com tested a clip for me, and said that it won't take flame because the material isn't heavy enough. Sorry about that.

Thanks Baz!

Casey
 
theoriginalspaceman said:
Hey 3rd - as usual, I have fallen behind. But I am pretty sure everything will be good to go and ready to start shipping by this weekend. That's my goal, anyways. Sorry for the delay.

Casey
Click to expand...

Cool, not a problem. I can be patient when the end result is worth the wait. I'll check back this weekend and if they're ready to ship I'll get you my info and wire you some funds. I'll be wanting at least 5 clips to go with the pry tool.
 
Thanks Friar, watching out for me ;-).

Hey Chris - the first batch had a small machining flaw, so I sold them for my hard costs ($38), which included material and machining cost, but not time. This batch will be $60. If you shoot me an email to thelastleaf1@gmail.com I'll put you on my mailing list and let you know when they're ready.

Thanks 3rdGen. I appreciate the support, and your patience!

Casey
 
Het dot - I would call it more of a bright purple... and the shorty will work on your Domino, but it will hit partially on the lock bar relief cutout, fyi.
Casey
 
Hey Chris - here are a couple pics of the V1.2 pry bar, almost ready to go. It's basically the same as the V1, just a few small tweaks that are difficult to notice. The V2 doesn't have the cutout, and is shaped a bit differently. That one should be ready in a month or so.
Casey
DSCN2080_zpsfjd98z9z.jpg
DSCN2081_zpsoz9typhz.jpg
 
Last edited:
Hey Chris, I don't have a thread for them. I've been selling them via word of mouth, but I have a website almost ready to go. If you'd like me to add you to the email list so I can let you know when they're ready, shoot me an email at thelastleaf1@gmail.com.

Thanks knife!

Casey
 
You must log in or register to reply here.
Back
Top