Introducing the Zero Tolerance 0801

That 0801 is calling me, especially since it's a Rexford design (he's closed his books, so no Rexford custom for me:(). Is there any chance that ZT will make some left-handed versions (and no, just drilling holes in the other side for the clip is not sufficient)?
 
I know this is just a prototype so I am holding out hope that the production version with come with the deep carry clips from the 0560 drill in all 4 corners. I think that clip would look better and fit with the milling on that knife.
 
momouppa said:
IMG_0111_zps82c66170.jpg
Click to expand...

I meant it might carry better if the pocket clip was closer to the end of the handle like in the pic below. It is harder because of the angle of the handle.

FY7A0947-Edit.jpg
[/QUOTE]

PLEASE do not use my photos without my permission. Note the copyright in the right hand corner.
 
bld522 said:
I'm glad to see ZT moving in this direction. One piece of information I'd love to know isn't stated in the specs, however . . .

How much does it weigh?

The 0801 looks like it could be heavier than a Southard. The Southard weighs 4.1 oz. I prefer my EDCs to weigh 4.0 oz or less.
Click to expand...
BobSig said:
Let me get back to you on that one.
Click to expand...
Any luck locating a scale yet, Bob? The reviewer on the BladeHQ video said the knife feels like it weighs around 5.0 ounces to him.
 
Last edited:
You must log in or register to reply here.
Back
Top