The New Snark Thread

Status
Not open for further replies.
The Warrior said:
Flux capacitor was out of sync.
Click to expand...
Activate hyperdrive!
ir70Q53.jpg
 
Anyone else see the pile of awesomeness going up on the block on the FB page?
 
Circle hooks never found their way under a bass bait, there would be no need to SWING and set the hook.
 
Craft show? Get them dainty doilies for dem beer mugs and cans!

Man I wish I could drink again...oh wait...guess not but one can always wish!
 
Was literally donning the Fonzie jacket for a ride to the post office and make a drop, when "pitter, patter, Pitter, Patter, PITTER, PATTER, CRASH!!!"
🤐 Ok, get the truck keys...
 
In June I had to change my eating habits because my blood glucose levels were out of wack bad first goal was to control my glucose levels. Once I got into it I started dropping weight. I set a secondary target for under 300 lbs this morning I was 299 lbs. The first of June I was 338
 
1066vik said:
how fast did you sell out Daiz?
Click to expand...

If only!
Sold half my inventory, which was totally fine. Didn't have any Birudashi on the table this year unfortunately. Those and the paring knives are usually popular (and lower-cost). Good news is I have a head-start on the next show, and/or inventory for other things. The venue that hosted me (it's a trail of artists across town) consigns for me anyway, so more stuff that can go in the case. Two previously interested parties weren't around today, so maybe a couple more will go too.

Met lots of people, a bunch of friends stopped by, bawled with Hefty Lefty's onocology nurse who randomly stopped in.
Good weekend. Scarfing leftover Indian food cold from the fridge because I skipped lunch!
 
tanglediver said:
Was literally donning the Fonzie jacket for a ride to the post office and make a drop, when "pitter, patter, Pitter, Patter, PITTER, PATTER, CRASH!!!"
🤐 Ok, get the truck keys...
Click to expand...
Hope the damage was very minimal :oops:
 
Geezus, Magnacut is expensive.
Just ordered some more. Gotta get my stencils updated too.

ETA: had planned for Magnacut to replace CPM154 as my high-wear stainless, but it's SO much more expensive that I think there's room for both for the time being. Ordered more of that too (and AEB-L).
 
Last edited:
I haven't tried that alloy yet, but I keep hearing good things about it.

I am pretty satisfied with CPM-3V and CPM-M4.

The highest carbide stuff I use is S110V by Spyderco, but it doesn't handle impacts very well.
 
Status
Not open for further replies.
Back
Top